Miele GAS KM 81-2 Instrucciones de operaciones descargar pdf (Pagina 10)

(CDN) (USA) Electrical connection

The automatic ignition requires connec- Technical data CDN / USA

tion to an a.c. single phase 120

V,

T

, . .„ ., .

oc

...

„„ ,, , r- Tota connected oad 25 W

60 Hz power supply. Fuse rating is

15 A. Actual power consumption Electrical connection to 3 prong wall

(during ignition only) is 25

W.

outlet:

T

. .. , . . . 120V/60Hz/15A

These appliances are factory equipped

with a power supply cord ready for Plug rating 10 A

connection to an electrically grounded

n

., ..

H

. ,

0 m

. , . . . .. ./

y

i i Power cord length 1.1 m (3 ft)

socket which complies with your local

electrical codes or with the:

National Electical Code ANSI/NFPA

No.

70-1481 for the USA

or

Canadian Electrical Code Part

Canada.

for

Ensure that the reeptacle is so

posi-

tioned that it is easily accessible when

the appliance is built in.

Check that data given on the data plate

under the appliance complies with the

main voltage.

WARNING:

THIS APPLIANCE MUST BE

GROUNDED.

[

Do not cut or remove the grounding

prong from this

plug.

18

AUS

Electrical connection AUS

Electrical connection of the appliance

should be undertaken by a suitably

competent person in strict accordance

with national and local safety regula-

tions.

For extra safety it is advisable to install

a residual current device (RCD), with a

trip current of 30 mA.

The appliances are supplied with a

mains cable for connection to single

phase 240

V,

50 Hz supply. The plug

rating and rated load are given on the

data plate.

Connection should be made by a

switched socket. The On-Off switch

should be easily accessible after the

appliance has been built-in.

Electrical connection NZ

The appliances are supplied with a

mains cable for connection to single

phase 230

V,

50 Hz supply. The plug

rating and rated load are given on the

data plate.

Important:

The wires in the mains lead are

col-

oured in accordance with the following

code:

Green/yellow = earth

Blue = neutral

Brown = live

NZ) Electrical connection

As the colours of the wires in the mains

lead of this appliance may not corre-

spond with the coloured markings ident-

ifying the terminals in your

plug,

pro-

ceed as follows:

The wire which is coloured green and

yellow must be connected to the termi-

nal in the plug which is marked with the

letter

E

or by the earth symbol -i or

col-

oured green or green and yellow.

The wire which is coloured blue must

be connected to the terminal which is

marked with the letter N or coloured

black.

The wire which is coloured brown must

be connected to the terminal which is

marked with the letter A or coloured red.

WARNING

THIS APPLIANCE MUST BE

EARTHED.

Technical data AUS (NZ)

Total connected load 25 W

Electrical connection:

50 Hz, 240 V (230 V)

Plug rating 10 A

Connection cable 1.10 m

If the connection cable needs replac-

ing,

only use cable with at least

3 x

1

mm

2

.

19

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 20 21

Comentarios a estos manuales

Sin comentarios