Miele GAS KM 81-2 Instrucciones de operaciones descargar pdf (Pagina 17)

(AUS)(NZ) Instructions for building-in

2 zone Combiset

1 element

2 elements

3 elements

4 elements

5 elements

4 zone Combiset

1 elements

2 elements

3 elements

Combination

One 2 zone

+ one 4 zone

Two 2 zone

+ one 4 zone

Three 2 zone

+ one 4 zone

One 2 zone

+ two 4 zone

Two 2 zone

+ two 4 zone

Depth

in

mm

490

490

490

490

490

490

490

490

490

490

490

490

490

Width

(=

Dimen-

sion B)

in mm

265

558

851

1144

1437

560

1143

1728

851

1143

1437

1436

1729

Extractor (e.g. DA 8-2)

For building in between two appliances:

- Dimension B increases by 90 mm.

For building in at the end ol a combination:

- Dimension B increases by 98 mm.

Stick the seal provided © under the

edge of the cooktop.

© Appliance

® Tensioning screw

® Clamp

© Worktop

©Seal

• Turn the tensioning screws ® in the

clamps in an anti-clockwise direction

into the appliance © until a resist-

ance is met and turn the clamp to

the left.

• Place the appliance into position,

turn the clamps and tighten the

ten-

sioning screws until the clamps

press into the worktop ©.

• Connect the appliance to the elec-

tricity supply.

• Connect the appliance to the gas

supply in accordance with gas sup-

ply regulations.

When building-in several Combiset

units,

a spacer bar must be fitted be-

tween each unit. It is supplied with its

own installation instructions.

32

(CDN)(USA) Conversion to alternative types of gas

When converting to alternative

types of gas (LP gas) or back to

Natural gas, the main jet and the

small jets of the burner must be

changed.

Turn off the gas main (if this ap-

pliance has already been installed),

turn off the electrical supply and

pull out the

plug.

Remove the wok/pan support, the

large burner cap, the burner ring

and the large burner cap base.

With a philipeshead screwdriver,

loosen the three screws.

Pull the controls for the gas burner

up and off.

Carefully raise the cooktop cover

slightly at the rear and pull forward.

Then carefully lift upwards and for-

wards. Ensure that the ground lead

which connects the cooktop and the

control panel is not damaged.

Screw in the new jets following the

table.

The gas cooktop unit is sup-

plied ready equipped for natural

gas;

the appropriate gas jet kit for cy-

linder gas, LPG (Liquefied Petro-

leum), is supplied with the appliance.

Reference table - jet sizes

USA/CDN

gas type burner size jet

adj.

screw

Natural Small No. 34 0.40 mm

Large 2.0 mm 0.88 mm

Propane Small No. 7 0.25 mm

Large 1.20 mm 0.54 mm

33

1 2 ... 12 13 14 15 16 17 18 19 20 21

Comentarios a estos manuales

Sin comentarios