Miele KM 2010 G Manual de instalación descargar pdf (Pagina 20)

The control is used to ignite the burner and to regulate the

strength of the flame.

ßThe gas supply is turned off

& Strong flame

/ Weak flame

The burners can only be switched on by pressing in the

appropriate control and turning it anti-clockwise, and

switched off by turning the control clockwise.

The following will cause damage to the appliance:

- Switching the burner on without pressing the control

down,

- Switching the burner on by turning the control

clockwise,

- Switching the burner off by turning the control anti-

clockwise.

The manufacturer will not accept liability for any damage

resulting from incorrect operation.

Switching on

^ The control for the burner required must be pressed in and

turned anti-clockwise to the large flame symbol to switch

on.

Pressing a burner control will automatically create a spark

on all burners. This is normal and no cause for concern.

When the flame ignites, keep the control pressed in for

8-10 seconds, and then let it go.

If the flame goes out, turn the control back to "ß". Wait for at

least 1 minute before attempting to re-ignite it, and press

and hold in the control for longer if required.

If the burner refuses to ignite the second time, turn the

control back to "ß" and see section "Problem solving guide".

Operation

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 51 52

Sin comentarios

Miele KM 2010 G Manual de instalación Pagina 20