Miele KM 2030 Manual de usuario descargar pdf (Pagina 32)

Fit the wall units and extractor hood

before fitting the hob to avoid

damaging the surface.

~

The room in which the gas hob is

installed must be at least 20 m

3

in size

with a door or window in it which can

be opened to the outside air.

~

The veneer or laminate coatings of

worktops (or adjacent kitchen units)

must be treated with 100 °C

heat-resistant adhesive which will not

dissolve or distort.

Any backmoulds must be of

heat-resistant material.

~

This equipment may only be used in

mobile installations such as ships,

caravans, aircraft etc. if a risk

assessment has been carried out by a

suitably qualified engineer.

~

An electric fryer must not be

installed directly next to a gas hob, as

the gas flames could ignite the fat in the

fryer. It is essential to maintain a

distance of at least 300 mm between

these two appliances.

~

A gas hob may not be built in over a

fridge, fridge freezer, freezer,

dishwasher, washing machine or

tumble dryer.

~

Ensure that the gas pipe and

electrical cable are installed in such a

way that they do not touch any parts of

the appliance which become hot. This

could cause damage.

~

The electrical cable (and flexible

gas connection pipes in countries

where applicable) must be installed in

such a way so that they do not come

into contact with any moving kitchen

parts (e.g. a drawer), and cannot

become trapped.

~

Observe carefully the safety

distances given on the following pages.

~

Do not use any sealant except

where expressly instructed to do so.

The seal underneath the appliance

provides a sufficient seal for the

worktop (see "General installation tips").

All dimensions in this instruction booklet

are given in mm.

Safety instructions for installation

32

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 51 52

Comentarios a estos manuales

Sin comentarios