Miele KM 2256 Manual de usuario descargar pdf (Pagina 39)

Solid wood and tiled worktops

a Worktop

b Fixing bracket (the fixing brackets

hold the lower section when the

upper section of the hob is

removed).

c Hob

d Gap

e Wooden frame 16 mm (to be

provided on site)

Corner radius of the tiled worktop ß R4

Make the worktop cut-out as shown

in "Building-in dimensions".

Fix the wooden frame e 4 mm below

the top edge of the worktop (see

diagram).

Fix the brackets b supplied.

Feed the hob connection cable down

through the cut-out in the worktop.

Centre the hob c in the cut-out.

Connect the hob to the mains (see

"Electrical connection").

Connect the appliance to the gas

supply (see "Gas connection").

^ Secure the appliance at the back and

front using the fixings supplied. See

"Securing the appliance".

^ Check that the hob works.

^ Seal the remaining gap d with a

silicone sealant that is heat-resistant

to at least 160 °C.

As the hob and worktop cut-out may

differ, the size of the gap d can vary.

Installation

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 55 56

Sin comentarios

Miele KM 2256 Manual de usuario Pagina 39