Miele KM 460 Manual de usuario

Installation instructionsCeramic hobsKM 460 / KM 461 / KM 463KM 464 / KM 465 / KM 466KM 468 / KM 469To avoid the risk of accidentsor damage to the mac

KM 465 / KM 466a Spring clamps^ Make the worktop cut-out followingthe dimensions shown above.^Remember to maintain a minimumsafety distance of 50 mm b

KM 468a Spring clamps^ Make the worktop cut-out followingthe dimensions shown above.^Remember to maintain a minimumsafety distance of 50 mm betweenthe

KM 469Position of spring clamps and safety brackets on KM 469a Spring clampsb Depth for building in including the electrical connection box located at

^Make the worktop cut-out followingthe dimensions shown above.^Remember to maintain a minimumsafety distance of 50 mm betweenthe hob and the back wall

Fitting the spring clamps andsafety brackets^Position the spring clamps a and thesafety brackets e supplied in thepositions shown in the illustrations

Granite worktopsOn granite worktops the spring clamps a and safety brackets e must be posi-tioned and secured using double-sided adhesive tape f. In a

Installing the appliance in graniteworktops^Feed the connection cable downthrough the cut-out.^ Lightly position the hob on the springclamps a.^ Using

All electrical work should be carriedout by a suitably qualified and com-petent person, in strict accordancewith national and local safety regula-tion

Electrical connection AUS/NZAll electrical work should be carried outby a competent person, in strict accor-dance with national and local safetyregula

Wiring diagramN.B. This appliance is supplied single phase only in the U.K. / AUS / NZElectrical connection19

Safety instructions. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3Installation . . . . . . . . . .

20

21

22

23

Alteration rights reserved / 0303This paper consists of cellulose which has been bleached without the use of chlorine.M.-Nr. 05 397 194 / V00

InstallationFit wall units and extractor hood be-fore fitting the hob, to avoid damag-ing the ceramic surface.The veneer or laminate coating ofworktop

Spray canisters, aerosols and otherinflammable substances should notbe stored in a drawer under the hob un-less there is a shelf separating thedrawer

Installation of appliance on wall with additional niche claddingHob with frame/bevel edge Flush fit hoba Masonryb Niche claddingc Upstandd Worktope Wo

KM 460 / KM 461a Spring clamps^Make the worktop cut-out followingthe dimensions shown above.^Remember to maintain a minimumsafety distance of 50 mm be

KM 463a Spring clamps^Make the worktop cut-out followingthe dimensions shown above.^Remember to maintain a minimumsafety distance of 50 mm betweenthe

KM 464a Spring clampsb Depth for building in including theelectrical connection box located atthe rear on the right hand sideapprox. 51 mm.c Height ab

Protective base^A protective base must be installedunderneath the hob. There must be agap of at least 15 mm between thehob and the base (see illustrat