Miele KM 460 Manual de usuario descargar pdf (Pagina 3)

Installation

Fit wall units and extractor hood be

-

fore fitting the hob, to avoid damag

-

ing the ceramic surface.

The veneer or laminate coating of

worktops (or adjacent kitchen

units) must be treated with 100°C

heat-resistant adhesive which will not

dissolve or distort.

Any backmoulds must be of heat-resis

-

tant material.

Ideally the hob should be installed

with plenty of space on either side.

There may be a wall at the rear and a

tall unit or wall at one side. On the other

side, however, no unit or divider should

stand higher than the hob (see illustra-

tions).

This equipment is not designed for

maritime use or for use in mobile

installations such as caravans, aircraft

etc. However it may be suitable for

such usage subject to a risk assess

-

ment of the installation being carried

out by a suitably qualified engineer.

a Minimum distance between

cut-out and tall unit/wall = 50 mm,

unless they are made from a

non-combustible material.

See: Installation of appliance on

wall with additional niche cladding.

recommended

possible, but not recommended

not allowed

Safety instructions

3

1 2 3 4 5 6 7 8 ... 23 24

Comentarios a estos manuales

Sin comentarios