Miele B 890 Información técnica descargar pdf (Pagina 31)

Technical Information

B890 Rotary Iron

5.15 Hinge Pressure Spring – Setting / Adjustment

Note

Setting should only be made with the heater plate lowered onto the

roller.

1. Lower the heater plate onto the roller.

2. Remove the 2 screws under the table from the motor unit cover.

3. Remove the cover.

4. Unscrew the bolt from the cross pin.

5. Apply locking compound to the end of the bolt.

6. Screw the bolt in such that the pressure spring is compressed to

a length of approximately 13/16 inches

Note

After correct setting, the gap between the bolt head and the cross

pin at the head of the bolt should be approximately 1/16 of an inch

with the heater plate lowered onto the roller.

5.16 Hinge Spring - Removal

1. Lift the handle (locking catch) at the right under the table and

hold the table.

2. Tilt the folding part of the ironer down until it is vertical and locks

into place.

3. Tilt the folding part of the ironer back up until the spring is

virtually un-tensioned.

4. Release the spring from its holder using needle-nose pliers.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 37

Sin comentarios

Miele B 890 Información técnica Pagina 31