Miele KM 5670 Manual de usuario Pagina 41

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 60
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 40
Installation work and repairs to
electrical appliances must only be
carried out by a suitably qualified
and competent person in strict
accordance with current local and
national safety regulations (BS 7671
in the UK). Repairs and other work
by unqualified persons could be
dangerous. The manufacturer
cannot be held liable for
unauthorised work.
What to do if...
... the hob or cooking zones cannot
be switched on
Check whether
the safety lock is activated.
If necessary, deactivate it (see
"Safety lock" and "Programming -
P4").
the mains fuse has tripped.
If none of the above is the case, then
disconnect the appliance from the
electricity supply for approx. 1 minute.
To do this:
switch off at the isolator, or
disconnect the mains fuse.
Reset the trip switch in the mains fuse
box, and switch the appliance back on.
If it still will not switch on, contact a
qualified electrician or the Miele
Customer Contact Centre.
... the hob can be switched on and
settings selected, but the cooking
zones do not heat up
Check whether you set the demo-mode
setting by mistake (see "Programming -
P0").
... the hob switches off while it is in
use, and the residual heat indicator
or a flashing F appears in the display
for at least one of the cooking zones
and, if applicable, an audible tone
sounds
One of the cooking zones has probably
been on for too long, or one of the
sensors may have been covered over
(see "Safety switch-off").
.. the heating element for one of the
cooking zones switches on and off
This is quite normal, and due to the
electronic regulation of the heating
element (see "How the cooking zones
work").
If the heating element switches on and
off when the highest setting has been
selected, this indicates that the
overheating protection mechanism has
triggered (see "Overheating
protection").
Problem solving guide
41
Vista de pagina 40
1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 59 60

Comentarios a estos manuales

Sin comentarios