Miele KM 5670 Manual de usuario descargar pdf (Pagina 47)

Safety instructions for

installation

Fit the wall units and extractor hood

before fitting the hob to avoid

damaging the appliance.

The veneer or laminate coatings of

worktops (or adjacent kitchen units)

must be treated with 100 °C

heat-resistant adhesive which will not

dissolve or distort.

Any backmoulds must be of

heat-resistant material.

This equipment may only be used in

mobile installations such as ships,

caravans, aircraft etc. if a risk

assessment has been carried out by a

suitably qualified engineer.

The hob may not be built in over a

fridge, fridge freezer, freezer,

dishwasher, washing machine or

tumble dryer.

After installing the hob, ensure that

the connection cable cannot come into

contact with the underside of the

appliance. Make sure that there is no

mechanical obstruction, such as a

drawer, which could damage it.

Observe carefully the safety

distances given on the following pages.

Do not use any sealant except

where expressly instructed to do so.

The sealing strip under the edge of the

top part of the hob provides a sufficient

seal for the worktop (see section

"Sealant").

All dimensions in this instruction booklet

are given in mm.

Installation

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 59 60

Sin comentarios

Miele KM 5670 Manual de usuario Pagina 47