Miele KM 5731 Manual de instalación descargar pdf (Pagina 49)

Safety instructions for

installation

Fit wall units and extractor hood

before fitting the hob to avoid

damaging the surface.

~

The veneer or laminate coatings of

worktops (or adjacent kitchen units)

must be treated with 100 °C

heat-resistant adhesive which will not

dissolve or distort.

Any backmoulds must be of

heat-resistant material.

~

This equipment may only be used in

mobile installations such as ships,

caravans, aircraft etc. if a risk

assessment has been carried out by a

suitably qualified engineer.

~

The hob may not be built in over a

fridge, fridge freezer, freezer,

dishwasher, washing machine or

tumble dryer.

~

These hobs must not be installed

above ovens or cookers unless these

have a built-in cooling down fan.

~

After installing the hob, ensure that

the connection cable cannot come into

contact with the underside of the

appliance. Make sure that there is no

mechanical obstruction, such as a

drawer, which could damage it.

~

If a protective shelf is installed under

the built-in hob, there must be a

minimum distance of 190 mm between

it and the top of the worktop to allow for

ventilation to the appliance. A gap of 10

mm is required at the back for feeding

the electrical cable through.

~

Observe carefully the safety

distances given on the following pages.

~

Do not use any sealant except

where expressly instructed to do so.

The seal underneath the appliance

provides a sufficient seal for the

worktop (see "Sealant").

All dimensions in this instruction booklet

are given in mm.

Installation

49

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 71 72

Comentarios a estos manuales

Sin comentarios